LynnBlakeGolf Forums

LynnBlakeGolf Forums (http://www.lynnblakegolf.com/forum/index.php)
-   24 Basic Components (http://www.lynnblakegolf.com/forum/forumdisplay.php?f=133)
-   -   Identity Theft (http://www.lynnblakegolf.com/forum/showthread.php?t=5899)

Yoda 01-01-1970 12:00 AM

Identity Theft
 

6bee1dee wrote:

Yoda wrote:

Phillygolf wrote:

[ But, in the act of extensor action - there is no 'pulling', it is an extending motion of the right arm...it is simply the right arm striving to become straight and in turn - stretches the left arm.

However, you could, especially during takeaway, stretch the shaft through pp#3 (which is actually a slight pushing motion via triceps) which also stretches the left arm - and therefore, from shoulder to hosel will form a straight line. This is structure.

[Bold by Yoda]




Per 6-B-1-D, Extensor Action is always a below-plane Pull. This Pull straightens ideally, the entire Primary Lever Assembly (both the Left Arm and Clubshaft / 6-A-2) through Pressure Point #3. However, with the less skillful player, this #3 Pressure Point Pull may induce Clubhead Throwaway. In which case, the Extensor Action should be limited to a straightening of the Left Arm only (by Pulling on the Left Thumb through Pressure Point #1). In either event, the Extensor Action is always a Pulling Action, never a Pushing Action.

You can't Push a piece of string into a straight line.



Extensor Action is a pull when you see it perform with the left arm. After reading this post and thinking about pressure points, with pp#1 and pp#3 on the trail side of the shaft, it is easy to conclude that both are pushes. The left arm of course creates a pull, but I always thought pp#1 was a push. I use little pp#1 since I'm a "puller." I'll have to bring my hands back to school.



Hans,

Do not confuse the Pressure Point Applications of Accumulator Power (6-C-1)-- and with them the differentiating Push versus Pull physics of Hitting andSwinging -- with their function as suppliers of the Non-accelerating Thrustnecessary for Power Package Mass (6-C-0--2), i.e., the application ofeither the #1 Pressure Point (Left Arm Stretch only) or the #3 Pressure Point(entire Primary Lever Stretch).

These are totally separate functions and Fog Control demands that theiridentities be maintained.



All times are GMT -4. The time now is 02:09 AM.