Lag Loading And Assembly Points -- Hitting And Swinging
Originally Posted by 12 piece bucket
Is the "Resisting the change of direction" stopping the hands travel limited to Hitters? Or is this used by Swingers not going to End as well?
"Resisting the Backstroke motion" (7-19-1) is the Hitter's method of Loading the Right Elbow to Drive (10-19-A) the entire Primary Lever Assembly (Left Arm and Club) from the Top (10-21-A). Should he choose to go to the End (10-21-C), he must resist the formidable tendency to then Accelerate the Clubshaft (only) Longitudinally (Pull it lengthwise as if a piece of string) rather than the entire Assembly Radially (Push it from behind as if an Axe Handle). Study 2-K and 7-23.
"Throwing the Club against the Lag Pressure Point" (7-19-3) with the Pivot is the Swinger's method of Loading the Left Wrist to Drag (10-19-C) the Secondary Lever Assembly (the Clubshaft only) from the Top or End (10-21-A/C).
For Full Strokes, Hitters may alternatively use a Downstroke Side Assembly Point (10-21-E). Or, a Downstroke Top Assembly Point (10-21-D) if the inclination toward Longitudinal Acceleration is properly Compensated. Swingers may alternatively use either procedure without concern for an improper Loading due to the chosen Assembly Point.
For Short Strokes, both Hitters and Swingers use the Side Assembly Point (10-21-B).
Threaded Mode
