![]() |
4 barrel swing/hit??
Well, it's nearing the end of the season here in Chicago and the grass ranges are closing up by sunday [:(]. So i usually take this last week i have on the turf and try to experiment and tinker a bit.
Well i have been fascinated with the 4 barrel swing/hit lately as i don't know a lot about it and just know that you are utilizing all 4 accumulators and whether you can actually "4 barrel swing" isn't a concern to me but what i was doing tonight was. Usually with the driver i'm a 3 barrel swinger. I have i believe standard wrist action (where the left wrist turns gradually to the plane) and i take it to the end. Then i have a slight hip bump and i pull very hard with my left (some right) arms into into impact and i let centrifugal force throw the club out. Works very well. I feel strong sensations in pressure points #2, #3, and #4. Well i said to myself, "what if around release point i give it some right arm. Let's see what that will do." Well let me tell you it did PLENTY. Higher and DEFINATELY longer. I'm here asking why and what exactly i was doing. I'll describe what i feel as happening below: During the downstroke as i'm pulling with both arms into impact and loading my #3pp and spinning that flywheel, right as my hands get around hip high (in my mind's eye/feel) i feel like i "put on the brakes" and then i thrust with my arm heavily. As Tommy T would say, "hit out down the line!" The results were much faster swing speeds, much noted higher pitch coming off the driver (which leads me to believe higher ball speeds) and longer distances. I also decided to try this with irons and although this type of motion would take some time to get used to, it has a benefit if i want to hit an iron high and/or with extra spin and/or distance. Not something i'd do all the time though. So is there a TGM explanation for this? The thing is that i was feeling the strong sensations of ALL 4pp this time and not just the 3. Thoughts? Questions? Thanks! |
Quote:
|
Quote:
It sounds like your 3 barrel swing is really a four barrel swing...with the comment(some right....in reference to the arms). See Tomasello's latest video series for the motion of the right arm, I think it we help you eliminate the problem of "putting on the brakes"....you want to LET the left hip rotate at release, if you put the brakes on the left hip you will create what is called "Quitting" which will generate a condition of clubhead throwaway. The three full stroke patterns that I believe you should use with all of your clubs (Primary Stroke Pattern, consult an AI for the best pattern)... which I believe will create the desired results your looking for are (accuracy and distance): 3 Barrel Swing Right Arm Swing 4 Barrel Hit. Alternate full stroke patterns for special situations 3 Barrel Hit 4 Barrel Swing I use the Right Arm swing (Primary) and 3 barrel hit (Secondary stroke pattern) for all shots. I combine them with all three hinge actions. DG |
DG, thanks for the comments.
When i said, "I feel like i put on the brakes," is a little misleading. It isn't like i was trying to stop the swing, it just "felt" like i "stopped spinning the gyroscope" and let the right arm take over from that. There was absolutely not quiting or steering and i actually IMPROVED my balance and finish position. |
Angled Hinge Jim?
|
No, it's a full roll horizontal hinge.
|
I used this swing for 9 holes today and had some pretty good results. Mainly used this swing for the driver and a couple iron shots.
I'll admit that it was much easier to make this swing "controllable" with an angled hinge though. Setup a little open and angle hinge it. Produced nice easy fades that went a long way. I did use this on one particular iron shot from the rough and it worked really well, stuck it to about 12 feet with an 8 iron from about 145 |
I got an instinct about something. Where do you feel the lag on the downstroke ?
|
Quote:
|
Quote:
|
Quote:
Do you feel the lag loading on the knuckle or directly on pp3... ? |
Quote:
This is different, maybe it is some sort of "swit" but you know what? When i need some "extra umph" this "move" provides it. |
Quote:
This entire "move" i'm doing is nothing more than your standard garden variety swinging driver stroke. The ONLY THING DIFFERENT, is that there is a conscious effort to thrust the right arm (the arm not the wrist mind you) at release point to create some extra swing speed. I will admit it is easier to do this move with an angled hinge that a horizontal hinge. If i thrust too early the face hangs open and it's FOOOOOOOOOORE RIGHT! Please go take a look at my post in holies/polies to see my 1st time results |
Cut and pasted from Yoda's archives...this is EXACTLY what I was doing:
Here's how to do it: From the Top, Drag Load (7-19) by Pulling the Butt End of the Club TOWARD THE PLANE LINE. Immediately thereafter, BEGIN A NON-AUTOMATIC RANDOM SWEEP RELEASE (10-24-B) - later you can kick it up a notch with the Automatic Snap Release (10-24-E) - by UNCOCKING YOUR LEFT WRIST STRONGLY DOWNWARD, ALSO TOWARD THE PLANE LINE. That takes only a fraction of a second, and just as you Feel the strong, Downward Uncocking Motion underway, USE ITS MOMENTUM TO BEGIN THE ROLL OF YOUR #3 ANGLE ON LINE through Impact. You've launched a THREE STAGE ROCKET: The DRAG LOAD established your initial Thrust; your UNCOCKING LEFT WRIST created the highest Velocity you will be able to achieve; and the #3 ACCUMULATOR PICKED UP THAT VELOCITY AND SUSTAINED IT INTO IMPACT. |
Quote:
The other thing you can do is watch the Tomasello videos... DG |
Just Do It
Quote:
Quote:
Doing... I hear (and I forget). I see (and I remember). I do (and I know). |
Quote:
Amen!!!! Preachin to the Choir... It's one thing to know the book... It's another to be able to do the book!!! It's another to own it!!!! Yoda..you own it !!! |
Quote:
-Listen to the Tomasello instruction -Watch the moves Tomasello makes -Do the drills Tomasello performs Then feel the smile on your face as you watch the little white ball go long and straight!!! :) Happy Thanksgiving Everyone. Yee Haawwwww DG |
A Miller Moment
Quote:
I luv ya, man! |
Quote:
Happy Holidays Lynn... DG |
| All times are GMT -4. The time now is 05:55 AM. |