Yes, I just started using air. Last night I blew a set of grips onto bare graphite shafts. It took a little getting used to the technique, but it was very effective and they are ready to use immediately. I'll keep you posted. I need to make a protector sleeve to aid in blowing off the grips. Here is a link to some good info. http://www.clubmaker-online.com/arnie.gripblow.html
Tried this technique. Works great - grips go on very quickly, and you can't mess it up since you can easily re-adjust. You can even take the grips off once you've installed them to add/remove masking tape until they are just right.
Threaded Mode
