Tripod Center Vote

[12 piece bucket]

2-J IMPACT ALIGNMENTS . . . Clubface alignment also includes the requirement that the center of the Clubhead arc be so located that the Clubface strikes the ball before it strikes the ground. If the Clubface is centered on the ball while soled behind it any distance whatsoever, the radius of the Clubhead arc must be shortened or the Club will meet the ground precisely where it had been soled. This procedure of shortening the radius of the stroke is popular – that is pulling in the Hands at Impact by raising the head and shoulders a guess-timated distance, or pulling back the Left Shoulder, or bending the Left Arm, all with that same “precision."

3-F-7-C BOBBING is raising and/or lowering the Head by faulty movement of the back or knees, and disrupts the Shoulder-to-ball radius

9-1 ZONE 1 . . . The Pivot involves twisting the body and shifting the weight during the Stroke so as to maintain balance, a motionless head and any required tilt of the torso. All motion is in a preselected sequence and spacing of whatever Components are being employed. Emphatically, Hands are not educated until they control the Pivot.

AXIS TILT Example – pouring tea.
Mechanical – To change direction, the helicopter Pilot alters the plane of the rotating blades by tilting their axis in the new direction.
Golf – To change the plane of the Shoulder Turn without moving the Head, the golfer must tilt the Shoulder Axis by moving the Hips.

BALANCE Example – a hula dancer.
Mechanical – State in which all opposing forces cancel each other out.
Golf – Holding the center of gravity of the body inside The Stance without moving the Head.

PIVOT Example – revolving door.
Mechanical – That motion of a body moving around a center point.
Golf – A multiple universal-joint assembly between the Stationary Head and the Stationary Feet holding the Clubshaft “On Plane” by positioning and adjusting the Lever Assembly, through the #3 Accumulator, as directed by the Right Forearm.

PIVOT CENTER Example – thetherball pole.
Mechanical – The point on which an assembly is suspended or erected to stabilize and limit that assembly’s possible travel – the Hinge Pin.
Golf – Some point on the body kept stationary throughout the Stroke, to stabilize the motion.


STATIONARY HEAD Example – a spinning skater.
Mechanical – Same as Pivot Center.
Golf – Chosing the Head – rather than Between the Shoulders as the Pivot Center.

That's all the head references that weren't clubHEAD or aHEAD in the book.

Let me know what you want next Boss . . . if anythang.