1/2 way back until 1/2 way down- flatter and more closed.
At least I'll start there- have to make a living first before I take a look at the whole thing- gotta go - the IRS and Bank are knocking on the front door- wait a minute the adrenaline was flowing but now I realize that I'm in Bucket's closet- it's his house- Ah! no worries!
The primary lever isn't on plane, the secondary lever is always on plane.
Bagger
Bagger- good point- just clarify it a little more- the primary lever isn't on the "swing plane" normally. It is has it's own plane with a flat left wrist i.e. the left arm and clubshaft are "in-line", and that is normally different than the swing plane. Only when the left shoulder, hand, and "clubhead" are on the "swingplane" is the primary lever "on the swing plane"- and that can happen- i.e. zero number three accumulator or your avatar picture looks like another situation where it might be on plane or close.
But your post wasn't much different than mine in that I didn't take the time to explain in detail the potential issues to my post- i.e. 1/2 back and 1/2 way down on a chip shot?, full shot? etc. etc. And I didn't take the time to explain it fully in regards to the entire swing and the relation of the #3 accumulator plane to the swing plane and does that change or have implications if I'm using a short shot or full shot, and flat plane or steep plane, small #3 or large #3, plane shift or no plane shift. Why? Haven't looked at it before and don't have time right now to check it out.
Hopefully your game is good! or getting better! because it is a great game to play!
1/2 way back until 1/2 way down- flatter and more closed.
At least I'll start there- have to make a living first before I take a look at the whole thing- gotta go - the IRS and Bank are knocking on the front door- wait a minute the adrenaline was flowing but now I realize that I'm in Bucket's closet- it's his house- Ah! no worries!
Good one! That one made me chuckle.
Oh hey! Say "What's up" to Ichabod Crane for me next time you pass the fridge.
Everyone that said parallel is on the right track. But this doesn't explain where they are parallel and thus not fully explaining the relationship. One more night before I post the answer
Everyone that said parallel is on the right track. But this doesn't explain where they are parallel and thus not fully explaining the relationship. One more night before I post the answer
They all come to the same "point" and that point is on 'the' plane, regardless of plane angle or loading action. I agree with Annikan that the rest can depend on multiple factors, but assume you must mean an 'ideal'.
__________________
"Support the On Plane Swinging Force in Balance"
"we have no friends, we have no enemies, we have only teachers"
Simplicity buffs, see 5-0, 1-L, 2-0 A and B 10-2-B, 4-D, 6B-1D, 6-B-3-0-1, 6-C-1, 6-E-2
Im now hoping for someone other than me to give a specific answer...
However when someone defines a new plane - are they allowed to name it ?
I will call it Jen's plane after my girlfriend (thats the plane in red btw)
Im going to get the answer eventually from someone, even if I have to drag you all kicking and screaming....lol
Not sure I got the full meaning of the graphic, but what I see is the red plane representing the perpendicular(to the plane of the left arm assembly) plane of the left wrist hinge pin, so the motion would be horizontal/parallel to the inclined plae of the left arm assembly until the swivel starts, and then the red plane would have to rotate to the finish position. Of course I could have completely misunderstood the graphic entirely.....
Hybrid Mode
