Where should the right shoulder be at impact and release?
Right Shoulder should move in a circle . . . see 2-H below . .
2-H SHOULDER MOTIONS The point may be made that it is impossible to inscribe perfect circles while the center is in motion – that is the turning Shoulder. The straight line requirements of the Compression Point are satisfied as long as both the Vertical and Horizontal Centers move precisely in unison. Direction control remains stable because both Centers are also moving in a circle – that is, the circumference of the Shoulder Turn.
The spine, between the shoulders, is the center of the Shoulder Turn only, not of the Left Arm, except by specific extension of the Swing Radius. Because, Swinging from the Wrists, the Left Shoulder, the Right Elbow, the Waist or the Feet, show it to have just to many exceptions. Though the “Head” Pivot Center is recommended, it is not at all mandatory.
But the Shoulders do have crucial On Plane functions – synchronizing and aligning the Pivot Motion and Thrust with those of the Power Package (Chapter 6). “On Plane” Right Shoulder Motion is possible only by titling its axis – the spine. See 7-14. In this area the Left Shoulder is helpless. The geometry of Shoulder Control deals only with Right Shoulder, for there are no guide lines for Left Shoulder control of the Right Shoulder. Therefore, variations in Right Shoulder location will vary the Left Shoulder location at Impact and, consequently, the Low Point location as well as the Angle of Approach (2-N).
Being a part of the Pivot and the Power Package, the Right Shoulder must reconcile them by moving with the greatest precision for thrust, speed, direction and distance. (7-3) So the Right Shoulder does not flap around haphazardly – it has many responsibilities. And variations in its Impact location will vary the Right Elbow’s Impact Bend and so may alter the Impact alignment of the Clubface. See 6-E and 7-23. The long Backstroke Shoulder Turn produces CIRCLE Path (10-23-E) and ARC of Approach procedures. The short Shoulder Turn produces “LINE” types of Delivery Path (10-23) and “ANGLE” of Approach procedures (2-J-3). So – if the Shoulder Turn is too great and takes the Hands inside the proper Angle of Approach (2-J-3), then you must shift to an Arc of Approach Delivery Line to “clear the Right Hip” (2-J-3). Or get an unwanted Pull. OR A SHANK. Otherwise, the Three Dimensions will become un-correlated including Compression Leakage (2-C-0) and an obvious struggle. As it goes back, so it tends to come down – because of the differences in Loading Characteristics (Components 11, 19, and 22).
Hybrid Mode
