I have been considering building a plane board. I have began to wonder if I should modify it for TGM. From what I can tell, the semi-circular part cut of the middle to allow for the address position usually has a radius of about 30 inches, leaving 18 inches on each side for the club head and part of the shaft to rest upon. I'm wondering if I should reduce this radius to just enough to allow me to take an address postition. My thinking is that this would allow me to not only rest the clubhead and a small portion of the shaft on the board, but the entire shaft and even my right fore arm and elbow. From there I could be sure that I am going up plane and back down plane. Comments or suggestions?
PUBLIC "-//W3C//DTD HTML 4.01 Transitional//EN" "http://www.w3.org/TR/html4/loose.dtd">
ERROR: The request could not be satisfied
504 Gateway Timeout ERROR
The request could not be satisfied.
We can't connect to the server for this app or website at this time. There might be too much traffic or a configuration error. Try again later, or contact the app or website owner.
If you provide content to customers through CloudFront, you can find steps to troubleshoot and help prevent this error by reviewing the CloudFront documentation.
Generated by cloudfront (CloudFront) HTTP3 Server
Request ID: CYJ0yH9s5o_i4DhSHLfytivLbkaqW8M2qwPp81hdG_kzbywkxZSQtg==
Threaded Mode
