Finish swivel - Page 2 - LynnBlakeGolf Forums

Finish swivel

Emergency Room - Swingers

Reply
 
Thread Tools Display Modes
  #1  
Old 06-19-2007, 05:46 PM
bambam's Avatar
bambam bambam is offline
Administrator
 
Join Date: Mar 2005
Location: Fishers, IN
Posts: 1,793
Originally Posted by libero View Post
I just wanted to know which of the two things
I must think about when approaching impact zone.
Ideally you aren't thinking about anything when approaching impact because there's not much you can do about it at that point All this stuff should be in the computer before you ever pull the trigger.

Originally Posted by libero View Post
On the other hand I'm
wandering why should be swivel of any importance (since the top of backswing,as Lynn states), if it occurs well after the ball is struck? Does it have any influence on the shot or not?
I'm sure others could add to this, but knowing what alignments you want to have at each station is critical. If you don't know how to swivel or even what a swivel look like, doing it properly will be pure luck. The swivel is a natural bridge from both arms straight to finish. Any other move there will probably introduce some compensations and have negative implications on impact.

Originally Posted by libero View Post
So I ask you bambam : is throw out action part of your conscious swing thoughts or not? If yes,how do you accomodate throw out with rolling? and still getting a horizontal hinge?
Where's 12 piece when we need him? He's had some good posts on throwout action recently.

Your release motion can be simultaneous (typical of a hitter) or sequenced (typical of a swinger). In a sequenced release you uncock then roll (check out the "are you ready to roll" video). You can increase/decrease overlap of those accumulator releases to increase thrust/velocity. If I had my book with me, I'd give you chapter numbers. Do a search on sequenced release and you'll get some good stuff.

Right now I am thinking about feeling the roll. The past few months, I was thinking about feeling the uncock, but that's becoming natural (shut up bucket). I hit pushes for a while during that process. If I roll before I uncock, fore left. If I don't roll, then I either get throwaway or a hinge action I didn't setup for...fore right.

SECGolf had a good reply to your question. It's possible you're trying to fix a symptom rather than a cause. If you have video or an instructor, check to make sure you aren't swaying, bobbing, or otherwise screwing up your plane. I found until Lynn and Ted helped me with some plane issues, I couldn't get my hands and the club to consistently do what I knew they were supposed to through impact.
__________________
Ben
Reply With Quote
  #2  
Old 06-20-2007, 08:14 AM
SECGolf SECGolf is offline
Senior Member
 
Join Date: Oct 2005
Location: Duluth, Georgia
Posts: 110
Originally Posted by libero View Post
Looks like I can't
perform both things at the same time. The outcome is this: If I think of
throw out I get well struck shots,but they're pushes. If I think of rolling
thru impact I still get good struck shots but they're pulls.
So I ask you bambam : is throw out action part of your conscious swing
thoughts or not? If yes,how do you accomodate throw out with rolling? and
still getting a horizontal hinge?

Clue: I never slice nor hook my shots,only pushes and pulls. What would the
doctor say?
Thanks again to all of you .
Having thought of this only because of personal experience (same problem), it really, really sounds like you are coming into impact over plane.

Related, as far as what to think about, ultimately, think of driving (swing - passively, hit - actively) down and out toward the plane. Because of your already installed hinge assembly (and preprogrammed Type of hinge assembly), hinging will occur as a result of thrust to the plane line. The tremendous momentum from these actions will necessitate that a finish swivel occurs. Now, actively causing, or actively monitering a finish swivel, for a period of time, might help the actions preceding the swivel (preceding actions will be "forced into place").

Think of a door. There is no need to think of hinging. The hinge assembly is already installed. All you have to do is push (drive the door). All "timing" - when the door will line up with the frame - is taken care of by the hinge assembly.

As far as over plane driving, focus on eliminating clubhead throwaway by establishing, producing and maintaining clubhead lag pressure (Clubhead feel). If you lose clubhead feel, you will have throw away.
Reply With Quote
Reply


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT -4. The time now is 11:05 PM.


Design by Vjacheslav Trushkin, color scheme by ColorizeIt!.